User Manual

d. Add the devices to the scene. You can select a device or multiple devices then
drag and drop them to the scene. To select multiple devices, select the first
device, hold down CTRL key then select the next device or devices. Once all the
devices are selected, drag and drop this to the scene.
e. You will be presented with a Confirm Add dialog with a list of all the devices you
selected. Assign the controller and responders by highlighting the device and
select controller/responder button. From this dialog you can also remove
devices.
Figure 43. Confirm Add dialog.
f. Select OK.
g. The system will add these devices to the scene. A System Busy dialog will be
with a progress bar will be shown. Depending on the complexity and the number
of other devices, especially with controllers/masters, it may take roughly 10
seconds to a few minutes to program the device(s) in becoming part of a scene.
Heed the note within the dialog box.
Figure 44. System Busy Dialog.
h. Set the scene attributes by adjusting the sliders for each device.