User Manual

7.1 Pull Down Menu and Apply Button
The pull down menu has a selection of Enable, Disable, Run, Run Else, Stop, Run at Boot and
Not Run at Boot. These are actionable commands that are entered in the applicable Enable or
Run at Boot column.
Enable – enables the program to run
Disable – disables the program so that it will not ever run unless enabled
Run – runs the program regardless of the condition
Run Else – runs the Else block of the program
Stop – Stops the program if currently running
Run at Boot – whenever the system is rebooted, this program runs regardless of the condition
Figure 46. Program Summary tab pull down menu.
To enter the command in the enabled column: