User Manual

Figure 33. ISY Node branch expanded showing devices.
Selecting a device in the INSTEON Device branch will show the device properties in the view
pane.
The pane will also have controls by means of a slider or buttons. These controls allow the user to
directly control and setup the device via the computer. Currently the ISY supports all SmartHome
lights, switches and dimmers. Depending on the device that is linked to the system, you will be
presented with the permissible control action the system can help you perform and automate.
For example in Figure 34 the KeypadLinc named as “Entry-1 Overhead” light was selected and its
properties are shown in the view pane.
On level and ramp rate adjustment are controlled with a slider control. On level sets the amount
of light within 0 and 100%, where 100% is full brightness or ON. Ramp rate sets the amount of
time it takes to reach the set ON level from OFF to ON and from ON to OFF.
Setting the device properties via the ISY does not require you to press the set button on the
device. Unlike manually setting the ramp rates and ON levels, you need not press the Set Button
to store the set values. All you need to do is set the sliders to the desired level or ramp rates.