User guide
Table Of Contents
- Installation and setup
- Username/Password
- Automatically add new devices to HomeSeer
- Display Insteon type descriptions
- Split Location/Name from ISY name using character
- Set HomeSeer Location to
- Set HomeSeer Location 2 to
- ISY Insteon Plug-in Logging Level
- Update Device Types
- Remove Duplicates
- Save
- Status Message Filter
- Device Filter
- Advanced Feature
- ISY Insteon Plug-in Status Screen
- ISY Insteon Plug-in Thermostat Control
- Device Control
- Triggers
- Conditions
- Actions
- Thermostat API
- ISY Insteon API
- Tips
- Error Messages
- Warning Messages
Create a folder for each floor; Main, Upstairs, Basement.
Create a folder for each room and put them in the appropriate floor folder so you end
up with something like this:
Upstairs
Guest bedroom
Master bedroom
Main
Kitchen
Dinning
Basement
Game room
This information can be imported into HomeSeer's device location fields. So Location
2 could be the floor and Location could be the room.
ISY first. By using an ISY, you are putting it in charge of your INSTEON devices. So make
sure you have everything functioning properly before starting the ISY Insteon Plug-in and
importing the ISY configuration. While the ISY Insteon Plug-in will try to stay current with
changes as they are made on the ISY, it is possible for the two to get out of sync. The
easiest way to re-synchronize the ISY Insteon Plug-in is to disable it and then re-enabled it.