User's Manual

UL-801 Installation Manual
Page 311
23-20-06 15 December 2011
(2) Sheet 2 of 2
MP
BP
+28 VDC POWER +28 VDC
POWER GND 4
CHASSIS GND 3
TP
DATA CLK 11C
CONFIGURATION
MODULE (P/N 108009)
24
+5 VDC 11D
24
DATA I/O 12C
24
GND 12D
24
CONFIG
MODULE
DISCRETE INPUT #3
12B
PARKING BRAKE SET = GND or OPEN
(OPTIONAL, AS REQUIRED)
DISCRETE INPUT #4
12C
DOOR n OPEN = GND or OPEN
(OPTIONAL, AS REQUIRED)
YELLOW
RED
BLUE
BROWN
20
2
16
5A
2
20
20
5
6
UL-801
(P/N 10801-XX)
----CONTINUED----
1 REFER TO APPLICABLE TECHNICAL MANUAL FOR PORT CONFIGURATIONS AND PIN ASSIGNMENTS.
2 CONFIGURATION MODULE IS MOUNTED ON THE REAR OF THE UL801 RACK.
3 IF FMS #1 IS NOT INTERFACED TO THE UL801, THEN CONNECT FMS #2 TO MP1C AND MP1D INSTEAD OF
THE WIRING (MP2C & MP2D) SHOWN ABOVE.
4 UNS1Esp, P/N 2019XX2XX, SUPPORTS BOTH UNILINK TEXT AND WEATHER GRAPHICS (RS-422 DISPLAY
DATA). UNS1Esp, P/N 2019XX1XX, SUPPORTS UNILINK TEXT DISPLAYS ONLY.
DISCRETE INPUT ACTIVE STATE IS CONFIGURABLE TO EITHER OPEN OR GROUND.
IT IS RECOMMENDED THAT DOOR 1 OPEN DISCRETE BE USED IF ONLY ONE DOOR DISCRETE IS TO BE CONFIGURED.
5
6
ALL WIRING IS TO BE 22 AWG UNLESS OTHERWISE INDICATED.
NOTE:
VHF ANTENNA
5
VHF ANTENNA