User's Manual

UL-801 Installation Manual
Page 101
23-20-06 15 December 2011
FAA Approval
1. General
Installation approval of the UniLink system is being accomplished under a variety of STCs
and Forms 337. For a new installation to be eligible for approval, it will be necessary to
apply to the FAA for an STC or to utilize an existing STC or Form 337.
This manual contains information directing the follow-on TC or STC applicant to include
specific maintenance instructions in the Aircraft Maintenance Manual or ICA when the Field
Loadable Software process is expected to be used as called out in FAA Order 8110.49
Section 5-4.
ACARS/graphics datalink functionality is NOT approved under TSO-C160.
Universal Avionics Systems Corporation received U.S. Federal Communication Commission
“Grant of Equipment Authorization” on TBD, in accordance with FCC Rule Part 87, with the
following transmitter specifications:
Mode
Output Power
(Minimum)
Frequency
Tolerance
Channel
Spacing
Frequency
Range
Emission
Designator
A 16 Watts ±30 PPM 25 kHZ 118.000 to
136.975 MHz
13K0A2D
2 15 Watts ±5 PPM 25 kHZ 118.000 to
136.975 MHz
14K0G1D
A. Applicable TSOs
• TSO-C160
Refer to the TSO Deviations section.
B. TSO Deviations
• TSO-C160 Section 3.f Environmental Qualification
The FAA granted a deviation to use the environmental conditions specified in
RTCA/DO-160F in lieu of DO-160E.
• TSO-C160 Section 4.a.(1) and 4.a.(2) Marking
The FAA granted deviations to allow the parts to marked using the model designation
system as referenced in 14 CFR § 21.619(b) Amdt. 21-92 in accordance with 14 CFR §
21.616(d) Amdt.21-92 and § 45.15b, Amdt. 45-26.
− Section 4.a.(1) Marking: Authorization to mark the LRUs with the Model Designation
in order to capture both the hardware part number and software control number
(SCN).
− Section 4.a.(2) Marking: Authorization to not mark the LRUs with the date of
manufacture. Each part will be marked with a unique serial number.