User's Manual

UL-801 Installation Manual
Page 518
23-20-06 15 December 2011
Configuration Error Messages
Text Action
HR-1 IS CONFIGURED FOR GRAPHICS BUT
NO HI-RES DISPLAY 1 SERIAL INTERFACE IS
CONFIGURED.
Configure UniLink either with an HI-RES DISPLAY 1
serial port or remove HR1 from the GRAPHICS setup
configuration.
HR-2 IS CONFIGURED FOR GRAPHICS BUT
NO HI-RES DISPLAY 2 SERIAL INTERFACE IS
CONFIGURED.
Configure UniLink either with an HI-RES DISPLAY 2
serial port or remove HR2 from the GRAPHICS setup
configuration.
HI-RES DISPLAY 1 SERIAL INTERFACE IS
CONFIGURED BUT NO HR-1 IS CONFIGURED
FOR GRAPHICS.
Configure UniLink either with a HR1 on the
GRPAHICS setup page or remove HI-RES DISPLAY 1
from the SERIAL configuration.
HI-RES DISPLAY 2 SERIAL INTERFACE IS
CONFIGURED BUT NO HR-2 IS CONFIGURED
FOR GRAPHICS.
Configure UniLink either with a HR2 on the
GRPAHICS setup page or remove HI-RES DISPLAY 2
from the SERIAL configuration.
PRE-DEPARTURE CLEARANCE IS ENABLED
BUT NO VALID AIRCRAFT TYPE IS PRESENT.
Configure UniLink either with a valid four-character
ICAO aircraft type designator in the TYPE field on the
A/C CONFIG page or with DISABLED in the
PREDEPARTURE field on the CLEARANCES page.
A750 VDR CONFIGURED ON LOW-SPEED
TRANSMIT PORT.
Configure the ARINC 429 transmit port, which is
configured to A750 VDR, to HIGH speed.
A429 TRANSMIT PORT SET TO A750 VDR
AND VM CMC
Configure the ARINC 429 transmit port to either A750
VDR or VM (Vibro-Meter) CMC.
A
RINC 429 PORTS CONFIGURED FOR ARINC
750 VDR BUT VHF RADIO TYPE NOT SET TO
ARINC 750 VDR
Configure RADIO TYPE to A750 VDR.
VHF RADIO TYPE SET TO ARINC 750 VDR
BUT NO ARINC 429 PORTS ARE
CONFIGURED FOR AN ARINC 750 VDR.
Configure ARINC 429 transmit and receive ports to
A750 VDR.
VHF RADIO TYPE SET TO A750 VDR AND
VDR MODE-SELECT DISCRETE IS
CONFIGURED BUT THE DISCRETE ACTIVE
STATE IS NOT SET TO OPEN
If an A750 VDR is installed and VDR voice select
discrete is configured, set the discrete ‘active’ state to
‘OPEN’.
VHF RADIO CONFIGURED BUT ICAO
AIRCRAFT ADDRESS MISSING
Configure UniLink with a legal ICAO aircraft address,
which ranges from 00000001 octal through 77777776
octal and is normally included on the aircraft
registration document.
ILLEGAL ICAO AIRCRAFT ADDRESS
Configure UniLink with a legal ICAO aircraft address,
which ranges from 00000001octal through 77777776
octal and is normally included on the aircraft
registration document.
FANS DISABLED – NO VALID AIRCRAFT
REGISTRATION IS CONFIGURED
Configure UniLink either with a valid aircraft
registration in the REGISTRATION field on the A/C
CONFIG page or with FANS as DISABLED.
FANS DISABLED – VHF RADIO OR SDU NOT
CONFIGURED
Configure UniLink with a VHF radio and/or an SDU, or
do not configure FANS.