User's Manual

UL-801 Installation Manual
Page 513
23-20-06 15 December 2011
Configuration Error Messages
Text Action
AN ADC AND A GNSS RECEIVER MAY NOT
BE CONFIGURED TOGETHER
Configure UniLink with DADC device(s) or GNSS
receiver. DADC and GNSS are dissimilar altitude
sources and cannot be configured concurrently,
configure UniLink accordingly.
AN ADC AND AN ARINC 702 FMS MAY NOT
BE CONFIGURED TOGETHER
A digital air data computer cannot be configured
concurrently with an ARINC 702 FMS, configure
UniLink accordingly.
AN IOP BUS MAY NOT BE CONFIGURED
TOGETHER WITH AN ARINC 702 FMS OR
THE GNSS RECEIVER.
An IOP bus cannot be configured concurrently with an
ARINC 702 FMS or with a GNSS receiver; configure
UniLink accordingly.
AN MCDU IS CONFIGURED BUT AN ARINC
702 FMS OR GNSS RECEIVER IS NOT
CONFIGURED.
When an MCDU is configured, configure UniLink with
an ARINC 702 FMS or a GNSS receiver.
IN ORDER FOR AN MCDU INSTALLATION TO
DISPLAY WEATHER MAPS AT LEAST ONE
DISPLAY MUST BE SET TO MFD-LR OR HR-1
OR HR-2
If the MCDU(s) is wired and configured as an ARINC
739A MCDU, configure UniLink with a low-resolution
MFD-640 and/or a high-resolution MFD-640/EFI-890R.
(See 0 and 2.)
IN ORDER FOR AN MCDU INSTALLATION TO
DISPLAY WEATHER MAPS NO DISPLAY MAY
BE SET TO CDU OR RCDU.
If the MCDU(s) is wired and configured as an ARINC
739A MCDU, configure UniLink with a low-resolution
MFD-640 and/or a high-resolution MFD-640/EFI-890R.
Ensure no MCDU, wired as an ARINC 739A MCDU, is
configured as a CDU. (See 0 and 2).
MORE THAN TWO REMOTE CDU GRAPHIC
DEVICES CONFIGURED
Configure UniLink with no more than two RCDU
displays.
REMOTE CDU-1 CONFIGURED WITHOUT
PRIMARY CDU-1 CONFIGURED.
When configuring a remote CDU for graphics,
configure both the RCDU and the corresponding
primary CDU.
REMOTE CDU-2 CONFIGURED WITHOUT
PRIMARY CDU-2 CONFIGURED.
When configuring a remote CDU for graphics,
configure both the RCDU and the corresponding
primary CDU.
REMOTE CDU-3 CONFIGURED WITHOUT
PRIMARY CDU-3 CONFIGURED.
When configuring a remote CDU for graphics,
configure both the RCDU and the corresponding
primary CDU.
NO MORE THAN FOUR DISPLAY
PROCESSORS MAY BE CONFIGURED ON
THE LOW-RES DISPLAY PORT
Configure UniLink with four or fewer graphic devices
on the low-resolution display serial port.
ARINC TEST DEVICE CONFIGURED.
Remove the TEST DEV selection from any ARINC
RECEIVE port; it is used for test purposes only.
A VHF RADIO IS CONFIGURED BUT NO
VALID AIRCRAFT REGISTRATION IS
CONFIGURED.
When an A750 VDR is configured, configure UniLink
with a valid aircraft registration in the REGISTRATION
field on the A/C CONFIG page.
A VHF RADIO IS CONFIGURED BUT NO
VALID AIRLINE/AGENCY ID IS PRESENT.
Configure UniLink with a valid airline/agency identifier
in the left portion of the AIRLINE ID field on the A/C
CONFIG page.