User's Manual

UL-801 Installation Manual
Page 512
23-20-06 15 December 2011
C. Configuration Error Messages
Configuration Error Messages
Text Action
MEMORY ALLOCATION ERROR--UNABLE TO
LOAD CONFIGURATION MODULE.
Attempt to store configuration. If condition persists
contact UASC.
ERROR READING CONFIGURATION
MODULE FROM NON-VOLATILE MEMORY.
Attempt to store configuration. If condition persists
contact UASC.
CONFIGURATION MODULE CRC CODE
FAILURE.
Attempt to store configuration. If condition persists
contact UASC.
CONFIGURATION MODULE VERSION
INCOMPATIBLE WITH SOFTWARE--
CONFIGURATION UPDATE REQUIRED.
Verify UniLink software update and configuration, and
store the configuration.
CONFIGURATION MODULE REVISION
OLDER THAN SOFTWARE REVISION--
CONFIGURATION UPDATE REQUIRED.
Verify UniLink software update and configuration, and
store the configuration.
AN ADC AND AN IOP BUS MAY NOT BE
CONFIGURED TOGETHER
An IOP bus cannot be configured concurrently with a
DADC. Configure UniLink accordingly.
CONFIGURATION UPDATED FROM OLDER
FORMAT. SOME DEFAULT VALUES USED.
CONFIGURATION SHOULD BE VERIFIED
AND RESAVED.
Once the configuration has been stored this message
will not appear. A newer configuration revision should
be used.
CONFIGURATION MODULE REVISION
NEWER THAN SOFTWARE REVISION--
EXTRA DATA IGNORED.
Once the configuration has been stored this message
will not appear.
ONE OR MORE ARINC DEVICES HAS A
TRANSMIT PORT BUT NO RECEIVE PORT.
Configure UniLink with a receive port for each
configured transmit port listed on the ARINC
TRANSMIT page.
ONE OR MORE ARINC DEVICES HAS A
RECEIVE PORT BUT NO TRANSMIT PORT.
Configure UniLink with a transmit port for each
configured receive port listed on the ARINC RECEIVE
page.
THE SAME DEVICE IS ASSIGNED TO MORE
THAN ONE ARINC 429 TRANSMIT PORT.
Any given device cannot be configured on more than
one transmit port; configure UniLink accordingly.
AN A702 FMS OR GENERIC DEVICE IS
CONFIGURED BUT LACKS A DEFINITION IN
THE CUSTOMER DATABASE.
Load UniLink with a customer database that supports
an ARINC 702 FMS or generic device, as appropriate.
MULTIPLE CMC DEVICES CONFIGURED.
Configure UniLink with either no CMC or a single
CMC, as appropriate, because UniLink cannot be
configured with multiple CMC devices.
THE UASC FMS THE ARINC 702 FMS AND
THE GNSS RECEIVER MAY NOT BE
CONFIGURED TOGETHER.
Configure UniLink with the same navigation source
only (i.e., the UASC FMS(s), the ARINC 702 FMS(s),
or the GNSS receiver) because UniLink cannot be
configured with dissimilar navigation sources
concurrently.