User's Manual

UL-801 Installation Manual
Page 506
23-20-06 15 December 2011
2. Error Messages
A complete list of defined error messages is shown in the following tables:
• The Pop-up Error Messages table shows the error conditions that result in a pop-up
window error message. These errors are deemed significant enough to warrant
immediate, detailed annunciation.
• The General Error Messages table shows the general error messages that may result in a
NEW ERROR MSG advisory alert, as well as the recommended actions for resolution.
• The Configuration Error Messages shows possible configuration error messages, as well
as the recommended actions for resolution.
• The Hidden Error/Status Messages shows unannunciated error/status messages that are
normally hidden from the error log.
A. Pop-up Window Error Messages
Pop-up Window Error Messages
Pop-up Window Text Condition
FMS/MCDU CONFIG ERROR. CONFIG NOT
SAVED.
User attempt to STORE configuration data that does
not configure the same FMS or MCDU on RX Port 1
and TX Port 1.
FMS/VDR SHARE TX PORT. CONFIG NOT
SAVED.
User attempt to STORE configuration data with an
ARINC 429 transmit port configured to interface to both
a UASC FMS and an ARINC 750 VDR.
FMS/MCDU CONFIG ERROR. CONFIG NOT
SAVED
User attempt to STORE configuration data with both a
UASC FMS/CDU and an MCDU configured together.
UNABLE TO WRITE TO CONFIG MODULE.
User attempt to STORE configuration data with
Configuration Module error.
DISPLAY PROCESSOR FAIL
A configured display processor has failed or
experienced a communication failure, or too many bad
slots have been detected.