User's Manual

UL-801 Installation Manual
Page 504
23-20-06 15 December 2011
I. Printer Test
(1) Verify that printer power is on and has passed its self-test.
(2) With the DATA page 1/4 displayed, press UNILINK LSK [3R]. The UNILINK
MENU 1/2 will display.
(3) Press the NEXT key.
(4) Press MAINTENANCE LSK [4L] to display the MAINTENANCE 1/3 page.
(5) Press TESTS LSK [2R] to display the TESTS page.
(6) Press PRINTER LSK [1L]. The printing message pop-up message will display and a
test pattern will be sent to the printer.
(7) The TESTS page will again display.
J. Checking the UL-801 FANS ALERTS Output Discretes
This procedure applies only to FANS-enabled aircraft.
(1) From the DATA 1/4 page, press UNILINK LSK [3R]. The UNILINK MENU 1/2
page will display.
(2) Press the NEXT key.
(3) Press MAINTENANCE LSK [4L] to display the MAINTENANCE 1/3 page.
(4) Press TESTS LSK [2R] to display the TESTS page.
(5) Press FANS ALERTS LSK [1R]. The FANS DISCRETE TEST IN PROGRESS pop-
up message will appear.
(6) Verify that all appropriate FANS Visual and Aural alerts activate momentarily.
K. Checking the UL-801 Self-Test (Optional)
This test simply reboots the UniLink. After the reboot process, verify that the UniLink
prompt becomes active.
L. Checking the UL-801 Weather Graphics using a SatCom-based
Telephony System
NOTE: Ensure that the selected DSP supports Weather Graphics uplinks.
(1) Press the DATA key to display the DATA 1/4 page.
(2) Press UNILINK LSK [3R] to display UNILINK MENU 1/2.
(3) Press WX MAPS LSK [2R] to display the WX MAP REQUEST page.
(4) Press SIG WX LSK [2R] and the SIGNIFICANT WX page will display.
(5) Press SEND LSK [4R]. This prompts UniLink to place a call to the selected DSP.
(6) The QUEUED and SENDING messages display. After a few minutes, the FMS
UniLink will display NEW WX ADVISORY under the ADVISORY area. Press the
LSK to the left of the ADVISORY message to display the message.
a) If a UniLink page is not currently displayed on the FMS, the MSG icon light will
flash.
(7) Press the MSG key on the FMS to display the MESSAGES 1/X page. The UNILINK
WX MAP RCVD message will appear.
(8) Pressing the UniLink prompt will display the UNILINK MENU 1/2 page.