User's Manual

UL-801 Installation Manual
Page 421
23-20-06 15 December 2011
5. TEL CONFIG
TEL CONFIG 1/2
AIR PHONE
Used for dial up
modem calls only
and uses an RS-232
serial port configured
for IRIDIUM or
AERO-M. It is
primarily used for
obtaining color
weather maps but
may also provide
VHF backup.
 NONE
 T-T AERO-M
When interfacing with Aero-M, configure the
Aero-M Data Port (via the Full Feature
Handset only, P/N 405621A) for 9600 baud,
Flow Control XON/XOFF, “+++”- Mode
Enable, Results Code Enabled and ARQ
Mode Enabled. Refer to the TT-3000 Aero-M
Installation Manual.
 IRIDIUM
Baud rate selection applies to Iridium
only. Select baud rate supported by
the software version as follows:
• Confirm the UniLink baud rate
compatibility with the vendor and
the selected DSP.
• Baud rate must be one of the
following:
 2400 BPS
 4800 BPS
 9600 BPS
• Contact the air phone
manufacturer for baud rate
compatibility with UniLink.
ACCESS NUMBER
The number dialed
by the selected AIR
PHONE. Used to
connect with the
selected Datalink
Service Provider’s
MODEM bank.
_________________________________ (Max 19 AN characters, 0-9, P,L, A)
The default value is to leave this field blank. Contact Universal Weather and Aviation
to obtain the Access Number.
Contact your DSP for the access number shown on the TEL CONFIG 1/2 page.
A “P” may be entered to insert a pause, an “L” may be entered to insert “#”, or an “A”
may be entered to insert “*” as required by the telephony network.
Subscription service for UniLink may be obtained through Universal Weather and
Aviation, Inc. at 1-801-231-5600.
WX MAPS
(Weather Maps)
If DISABLED is
selected, it is
required that NONE
is selected in the AIR
PHONE section.
 ENABLED  DISABLED