User's Manual

UL-801 Installation Manual
Page 330
23-20-06 15 December 2011
(2) Sheet 2 of 2 - 4/5” FPCDU/MCDU
TP
9A
9B
RS-422 DISPLAY
DATA TX #3
RS-422 DISPLAY
DATA RX
9C
9D
RS-422 DISPLAY
DATA RX #3
RS-422 DISPLAY
DATA TX
P3
P3
E
F
B
C
D
E
F
B
C
D
SHIELD GND
SHIELD GND
UL-801
(P/N 10801-XX)
----CONTINUED----
RS-422 DISPLAY
DATA RX
RS-422 DISPLAY
DATA TX
1413
1413
BOTH 4 AND 5 FPCDUs ARE WIRED IN THE SAME MANNER.
14
BOTH THE 4 AND 5 FPCDUs, P/Ns 1117-2-X1X AND 1018-2-X1X, SUPPORT BOTH UNILINK TEXT AND WEATHER GRAPHICS (RS-422 DISPLAY DATA).
OTHER 4 AND 5 FPCDUs, P/Ns
1117-X-X00 AND 1018-X-X00, SUPPORT UNILINK TEXT ONLY.
13
4
REFER TO APPLICABLE TECHNICAL MANUAL FOR PORT CONFIGURATIONS AND PIN ASSIGNMENTS.
1
CONFIGURATION MODULE IS MOUNTED ON THE REAR OF THE UL801 RACK.
5
IF FMS #1 IS NOT INTERFACED TO THE UL801, THEN CONNECT FMS #2 TO MP1C AND MP1D IN LIEU OF MP2C AND MP2D SHOWN ABOVE.
2
DISCRETE INPUT ACTIVE STATE IS CONFIGURABLE TO EITHER OPEN OR GROUND.
3
IT IS RECOMMENDED THAT DOOR 1 OPEN DISCRETE BE USED IF ONLY ONE DOOR DISCRETE IS TO BE CONFIGURED.
7
ANY AVAILABLE DISCRETE OUTPUT PIN MAY BE USED.
12
OPTIONAL: CPDLC CNECT ANNUNCIATOR. LABEL AS REQUIRED.
11
OPTIONAL: CONFIGURE DISCRETE OUTPUT FOR CPDLC CNECT (CONNECT).
10
CONNECT TO AN AURAL ALERTING DEVICE OR AN AURAL WARNING GENERATOR. USE SONALERT P/N SCE028LD2TT1B OR EQUIVALENT.
8
CONFIGURE DISCRETE OUTPUT FOR FANS VISUAL.
9
CONFIGURE DISCRETE OUTPUT FOR FANS AURAL.
6
WHITE ATC LETTERING RECOMMENDED. USE ANNUNCIATOR P/N EATON 582-10 A0 B0 C3 F4 L5 N1 (D) P12,12 ATC OR EQUIVALENT.
ALL WIRING IS TO BE 22 AWG UNLESS OTHERWISE INDICATED.
THE FMS MUST BE SCN 1000.5/1100.5 OR LATER TO SUPPORT FANS.
NOTES:
#1 4"/5 FPCDU/MCDU
(P/N 1117-X-X1X,
P/N 1018-X-X1X,
P/N 1025-XX-XXX)
#2 4"/5 FPCDU/MCDU
(P/N 1117-X-X1X,
P/N 1018-X-X1X,
P/N 1025-XX-XXX)
WIRING WITHIN THE DASHED LINES APPLIES ONLY WITH FANS ENABLED.
15
CONFIGURE AS A LO-RES DISPLAY.
16
16
A
B
A
B
A
B
A
B
A
B
A
B