User's Manual

UL-801 Installation Manual
Page 326
23-20-06 15 December 2011
(2) Sheet 2 of 2
MP
BP
+28 VDC POWER +28 VDC
POWER GND 4
CHASSIS GND 3
TP
11C
CONFIGURATION
MODULE (P/N 108009)
24
11D
24
12C
24
12D
24
DISCRETE INPUT #3
12B
PARKING BRAKE SET = GND or OPEN
(OPTIONAL, AS REQUIRED)
DISCRETE INPUT #4
12C
DOOR n OPEN = GND or OPEN
(OPTIONAL, AS REQUIRED)
YELLOW
RED
BLUE
BROWN
20
16
5A
2
20
20
11
12
UL-801
(P/N 10801-XX)
----CONTINUED----
DATA CLK
+5 VDC
DATA I/O
GND
CONFIG
MODULE
VHF ANTENNA
13
10
6
7
5
8
4
UNS1Espw SUPPORTS BOTH UNILINK TEXT AND WEATHER GRAPHICS USING RS-422 DISPLAY DATA.
2
3
9
1
REFER TO APPLICABLE TECHNICAL MANUAL FOR PORT CONFIGURATIONS AND PIN ASSIGNMENTS.
IF FMS #1 IS NOT INTERFACED TO THE UL801, THEN CONNECT FMS #2 TO MP1C AND MP1D INSTEAD OF THE
WIRING (MP2C & MP2D) SHOWN ABOVE.
11
ANY AVAILABLE DISCRETE OUTPUT PIN MAY BE USED.
OPTIONAL: CPDLC CNECT ANNUNCIATOR. LABEL AS REQUIRED.
OPTIONAL: CONFIGURE DISCRETE OUTPUT FOR CPDLC CNECT (CONNECT).
CONNECT TO AN AURAL ALERTING DEVICE OR AN AURAL WARNING GENERATOR. USE SONALERT P/N SCE028LD2TT1B OR EQUIVALENT.
CONFIGURE DISCRETE OUTPUT FOR FANS VISUAL.
CONFIGURE DISCRETE OUTPUT FOR FANS AURAL.
WHITE ATC LETTERING RECOMMENDED.
USE ANNUNCIATOR P/N EATON 582-10 A0 B0 C3 F4 L5 N1 (D) P12,12 ATC OR EQUIVALENT.
12
13
CONFIGURATION MODULE IS MOUNTED ON THE REAR OF THE UL801 RACK.
DISCRETE INPUT ACTIVE STATE IS CONFIGURABLE TO EITHER OPEN OR GROUND.
IT IS RECOMMENDED THAT DOOR 1 OPEN DISCRETE BE USED IF ONLY ONE DOOR DISCRETE IS TO BE CONFIGURED.
ALL WIRING IS TO BE 22 AWG UNLESS OTHERWISE INDICATED.
THE FMS MUST BE SCN 1000.5/1100.5 OR LATER TO SUPPORT FANS.
NOTES:
5
VHF ANTENNA
14
WIRING WITHIN THE DASHED LINES APPLIES ONLY WITH FANS ENABLED.