User's Manual

UL-801 Installation Manual
Page 324
23-20-06 15 December 2011
(2) Sheet 2 of 2
MP
BP
+28 VDC POWER +28 VDC
POWER GND 4
CHASSIS GND 3
TP
11C
CONFIGURATION
MODULE (P/N 108009)
24
11D
24
12C
24
12D
24
DATA CLK
+5 VDC
DATA I/O
GND
CONFIG
MODULE
12B
PARKING BRAKE SET = GND or OPEN
(OPTIONAL, AS REQUIRED)
12C
DOOR n OPEN = GND or OPEN
(OPTIONAL, AS REQUIRED)
YELLOW
RED
BLUE
BROWN
20
16
5A
2
20
20
14
DISCRETE INPUT #3
DISCRETE INPUT #4
13
UL-801
(P/N 10801-XX)
----CONTINUED----
ALL WIRING IS TO BE 22 AWG UNLESS OTHERWISE INDICATED.
THE FMS MUST BE SCN 1000.5/1100.5 OR LATER TO SUPPORT FANS.
NOTES:
VHF ANTENNA
CONFIGURE: SERIAL LOW RESOLUTION DISPLAY.
4
UNS1Ew SUPPORTS BOTH UNILINK TEXT AND WEATHER GRAPHICS USING RS-422 DISPLAY DATA.
2
1
REFER TO APPLICABLE TECHNICAL MANUAL FOR PORT CONFIGURATIONS AND PIN ASSIGNMENTS.
3
IF FMS #1 IS NOT INTERFACED TO THE UL801, THEN CONNECT FMS #2 TO MP1C AND MP1D IN LIEU OF MP2C AND MP2D SHOWN ABOVE.
5
WHITE ATC LETTERING RECOMMENDED. USE ANNUNCIATOR P/N EATON 582-10 A0 B0 C3 F4 L5 N1 (D) P12,12 ATC OR EQUIVALENT.
6
ANY AVAILABLE DISCRETE OUTPUT PIN MAY BE USED.
11
OPTIONAL: CPDLC CNECT ANNUNCIATOR. LABEL AS REQUIRED.
10
OPTIONAL: CONFIGURE DISCRETE OUTPUT FOR CPDLC CNECT (CONNECT).
7
CONFIGURE DISCRETE OUTPUT FOR FANS VISUAL.
8
CONFIGURE DISCRETE OUTPUT FOR FANS AURAL.
CONFIGURATION MODULE IS MOUNTED ON THE REAR OF THE UL801 RACK.
12
13
DISCRETE INPUT ACTIVE STATE IS CONFIGURABLE TO EITHER OPEN OR GROUND.
14
IT IS RECOMMENDED THAT DOOR 1 OPEN DISCRETE BE USED IF ONLY ONE DOOR DISCRETE IS TO BE CONFIGURED.
12
9
CONNECT TO AN AURAL ALERTING DEVICE OR AN AURAL WARNING GENERATOR. USE SONALERT P/N SCE028LD2TT1B OR EQUIVALENT.
5
VHF ANTENNA
15
WIRING WITHIN THE DASHED LINES APPLIES ONLY WITH FANS ENABLED.