User's Manual

UniLink UL-800/801
Operator’s Manual
23-20-06.01 17
December 2011
ATIS Request
Menu navigation: UNILINK MENU 1/2 > FLIGHT INFO > D-ATIS
The D-ATIS page is used to request local arrival or departure
Automatic Terminal Information Service (ATIS).
To request ATIS:
1. Press D-ATIS, LSK [1L] on the FLIGHT INFO page. The D-ATIS
page will display.
2. With AIRPORT active, enter the Airport Identifier and press
[ENTER], or accept the default destination airport from the FMS
flight plan.
NOTE: If an incomplete identifier is entered, the message TOO FEW
CHARACTERS will display and the field will flash. Pressing
the LSK and re-entering a complete identifier will correct the
error.
3. DEPT is the default type of ATIS. Press TYPE, LSK [2R] to toggle
the field between ARRV and DEPT as needed.
4. Press SEND, LSK [4R] to place the message in queue for
transmission.
NOTE: If the information on this page is incomplete, the pop-up
window DATA REQUIRED will display and the SEND prompt will not
enable.