User's Manual

UniLink UL-800/801 FANS
SCN 30.X
Operator’s Manual
62 23-20-06.02
December 2011
NOTE: If no data was entered in the ALTITUDE field, or either
HIGHER or LOWER selected, the pop-up window DATA
REQUIRED will display.
5. Press FREE-TEXT, LSK [3L] and enter text as needed.
NOTE: Text is limited to 24 characters on the page (text will not
wrap).
6. Press SEND, LSK [4R] to put the request in queue for
transmission.
SPEED
Menu Navigation: UNILINK MENU > ATC > EXPECT > SPEED
Speed negotiation requests can be made for specific speeds (Single)
or speed ranges (Block).
Speed – Single:
1. Press SPEED: LSK [2L]. The ATC EXP SPEED – SINGLE page
will display.
2. With SPEED active, enter a desired speed as follows:
• To enter speed in IAS (knots) - enter the speed value (i.e. 235)
and press [ENTER]. The entered value will be followed by IAS.
• To enter a Mach value - type M, use the [ + ] key to place a
period, then enter the value. Press [ENTER] and an M will
display after the entered value.
• To enter speed in IAS KPH – enter the speed value (i.e., 235),
then enter KM and press [ENTER]. The entered value will be
followed by KM IAS.