User's Manual

UniLink UL-800/801 FANS
SCN 30.X
Operator’s Manual
52 23-20-06.02
December 2011
4. Press REVIEW, LSK [4L]. The ATC REVIEW 1/X page will
display, reflecting the information entered on the ATC REQ
SPEED page.
NOTE: If no data was entered in the SPPED field, the pop-up window
DATA REQUIERED will display.
5. Press FREE-TEXT, LSK [3L] and enter information as needed.
NOTE: Text is limited to 24 characters on the page (text will not
wrap).
6. Press SEND, LSK [4R] to put the speed request in queue for
transmission.
To make a speed request - Block Speed:
1. From the ATC REQUEST page, press Speed, LSK [3L]. The
ATC REQ SPEED – SINGLE page will display.
2. Press BLOCK, LSK [4R]. The ATC REQ SPEED - BLOCK page
will display.
3. With SPEED active, enter a desired speed as follows:
• To enter speed in IAS (knots) - enter the speed value (i.e. 235)
and press [ENTER]. The entered value will be followed by IAS.
• To enter a Mach value - type M, use the [ + ] key to place a
period, then enter the value. Press [ENTER] and an M will
display after the entered value.
• To enter speed in IAS KPH – enter the speed value (i.e., 235),
then enter KM and press [ENTER]. The entered value will be
followed by KM IAS.