User's Manual

UniLink UL-800/801 FANS
SCN 30.X
Operator’s Manual
23-20-06.02 51
December 2011
SPEED
Menu Navigation: UNILINK MENU > ATC > REQUEST > SPEED
Speed requests can be made for SINGLE or BLOCK speeds. SINGLE
speeds are specific, whereas BLOCK speeds refer to a speed range
or “block.” Consequently, speed requests will be made from either the
ATC REQ SPEED – SINGLE or ATC REQ SPEED – BLOCK page.
To make a speed request - Single Speed:
1. Press SPEED, LSK [3L] on the ATC REQUEST page. The ATC
REQ SPEED – SINGLE page will display.
2. With SPEED active, enter a desired speed as follows:
• To enter speed in IAS (knots) - enter the speed value (i.e. 235)
and press [ENTER]. The entered value will be followed by IAS.
• To enter a Mach value - type M, use the [ + ] key to place a
period, then enter the value. Press [ENTER] and an M will
display after the entered value.
• To enter speed in IAS KPH – enter the speed value (i.e., 235),
then enter KM and press [ENTER]. The entered value will be
followed by KM IAS.
Speed Data Ranges:
Units
Lower Limit
Upper Limit
Resolution
Knots IAS 70 380 10
KPH IAS 100 1370 10
Mach 0.61 6.04 0.01
3. Press DUE TO, LSK [1R] and toggle between WEATHER, A/C
PERF, or NONE as applicable (default is NONE).