User manual

UAD Powered Plug-Ins - 300 - SPL Transient Designer
Signal This 4-stage “LED” indicates the presence of audio signals at the
input of the plug-in. When the input signal is below -25dB, the in-
dicator is off. At -25dB to -19dB, the indicator glows slightly. At -
18dB to -10dB, it lights with medium intensity. At -9dB to 0dB, it
shines brightly.
Overload The Overload “LED” illuminates when the signal level at the out-
put of the plug-in reaches 0dBFS. The indicator matches the be-
havior of the original hardware unit. However, in the software
plug-in version, the output can be “overloaded” without causing
distortion.
Link Link indicates when stereo operation is active. It illuminates when
used in a stereo-in/stereo-out or mono-in/stereo out configuration.
It does not illuminate when used in a mono-in/mono-out configu-
ration.
Note: Link is an indicator only; it does not control any plug-in parameter.
On/Power The On and Power switches determine whether the plug-in is ac-
tive. Click the On or Power switches to change the state. On and
Power illuminate when the plug-in is active.
When the plug-in is inactive, processing is disabled and UAD DSP
usage is reduced.
Note: The On and Power switches perform the exact same function.
WebZine Article
An interesting article about the SPL Transient Designer is available in the “Ask
The Doctors” section of our November 2007 WebZine:
http://www.uaudio.com/webzine/2007/november/index2.html