User manual

UAD Powered Plug-Ins - 176 - Pultec and Pultec-Pro
Pultec Latency
The Pultec and Pultec-Pro plugins introduce an additional 13 samples of delay
due to upsampling when the session sample rate is below 100kHz. This ad-
ditional latency does not occur at sample rates above 100kHz. You may en-
ter a value of 13 in the “Samples” parameter in DelayComp or TrackAdv to
compensate. See “Compensating for Pultec and Pultec-Pro” on page 55 for more
information.
Note: Compensating for Pultec and Pultec-Pro is not required if the host appli-
cation supports full plugin delay compensation throughout the signal path, or
when it is used on outputs. See “Host PDC Implementation” on page 50.
Pultec EQP-1A Screenshot
Pultec EQP-1A Controls
The EQP-1A can control three frequency ranges simultaneously, using three
groups of interacting parameters.
The first group controls the low frequencies and has three controls: boost, at-
tenuation, and frequency select. The second group controls the high frequen-
cies and has three controls: boost, bandwidth, and frequency select. The third
group also controls the highs and has two controls: attenuation amount and
frequency select.
The placement and grouping of the sections and their related controls are
shown in Figure 67 on page 177.
Figure 66. The Pultec EQP-1A Program Equalizer plugin window