Instruction Manual

UAD Powered Plug-Ins Manual - 126 - Chapter 10: UAD ExpressCard Products
2. Power down the ExpressCard, using the following method as defined by
the operating system:
• (Windows) In the Windows Task Bar, click the Safely Remove Hardware
icon, and select “Safely remove Universal Audio UAD-1 DSP card”
(Figure 26 on page 126).
• (Mac) In the Menu Bar, click the ExpressCard status menu icon, and select
“Power off Card” (Figure 27 on page 126)
3. Turn off the power switch on the back of the UAD-Xpander.
4. Remove the UAD ExpressCard from the expansion slot.
UAD-Xpander disconnection is complete.
Reconnect Once the UAD-Xpander has been disconnected for any reason, the computer
must be rebooted with the UAD-Xpander connected. Follow the “Startup Se-
quence” on page 124 for reconnection instructions.
System Sleep
Windows System Sleep (hibernate) is not supported when using UAD-Xpander under
Windows. Sleep should be disabled while the UAD-Xpander is connected.
Figure 26. ExpressCard Power Down (Windows)
Figure 27. ExpressCard Power Down (Mac)