Instruction Manual

UAD Powered Plug-Ins Manual - 109 - Chapter 9: UAD Delay Compensation

• Compensating for upsampled UAD plug-ins is not required when these plug-

ins are used for program material on the output bus, where latency is not a

consideration.

• If only one latency value is shown in T

able 7 on page 110, the value ap-

plies to both UAD–1 and UAD-2. N/A means that sample rate is not sup-

ported.

• UAD Pultec-Pro only requires one compensation per instance. For example,

if using both MEQ-5 and EQP-1A within a single Pultec-Pro, only one in-

stance compensation is required.

• Since the maximum Samples value in one DelayComp instance is 128,

more than one DelayComp instance will be required (in series) if the com-

pensation value from T

able 7 on page 110 exceeds 128.

• Latency compensation techniques for upsampled plug-ins apply to UAD

rack Advance (page 113) as well.

• The latency in Table 7 on page 110 is also produced when LiveTrack mode

(page 89) is used with upsampled plug-ins.

• Upsampled plug-in latency cannot be displayed in the “Plug-In Latency Sec-

tion” on page 66 due to technical limitations.