User Manual

UAD Powered Plug-Ins Manual - 79 - Chapter 7: Using UAD Powered Plug-Ins
Text Entry Parameter values can be modified directly with text entry. To enter a param-
eter value using text entry, single-click the parameter value text. The text value
will highlight, indicating it is ready to receive a new value. Type in a new
value, then press Return, Enter, or Tab, or click outside of the text box. Press
Esc if you want to revert to the prior setting without entering the new value.
Values entered via text entry are rounded to the closest significant digit. If an
entered value is out of range, it will be ignored.
To enter time values, the units must be specified. m =milliseconds, and s = sec-
onds. Examples: 400 milliseconds = .400s or 400m; 1.5 seconds = 1.5s or
1500m.
Scroll Wheel If your mouse has a scroll wheel, it can be used to adjust knob and slider con-
trols if the host application supports this functionality. Place the mouse cursor
over any knob or slider control to increment or decrement the parameter value
with the scroll wheel.
Keyboard
Control
(Macintosh)
If you control-click a control it selects that control for keyboard control. This is
useful for when you're in circular mode, and you want to fine-adjust a control.
Normally, clicking on a control in this mode makes the value jump to where
you clicked. Control-clicking will select the control so that you can use the key-
board to adjust it, without making its value jump first.
Shortcuts
Table 3 on page 80 lists the keyboard shortcuts that are available for modi-
fying parameter values. When using keyboard shortcuts, the last edited con-
trol will be modified (or, on Macintosh, you can use control-click to select a
different control as the target for keyboard shortcuts without changing the con-
trol's value).
Note: Not all host applications support sending keystrokes to plug-ins.