User Manual

UAD Powered Plug-Ins Manual - 352 - Chapter 38: Moog Multimode Filter
Moog Filter SE
Overview The UAD Moog Filter SE is derived from the UAD Moog Filter. Its algorithm
has been revised (primarily the elimination of the Drive circuit) in order to pro-
vide sonic characteristics very similar to the Moog Filter but with significantly
less DSP usage. It is provided to allow Moog Filter benefits when DSP
resources are limited. The UAD Moog Filter SE sounds great even without
Drive, and is very usable in many situations.
The Moog Filter SE interface can be differentiated from the full Moog Filter by
color and the module name. The Moog Filter SE is uses the “Luna” back-
ground and maple sides borrowed from the Voyager “Select Series.” The full
version uses the Voyager's “electric blue” backlighting and mahogany sides.”
Moog Filter SE
Controls
The Moog Filter SE controls are nearly the same as the Moog Filter. The
exceptions are the Drive related controls (“Drive” and “Boost”) are unavail-
able on the SE model, and the “Drive” control is replaced with a straight
(non-modeled) “Gain” control.
Please refer to the Moog Filter section for Moog Filter SE control descriptions
(see “Moog Filter Controls” on page 346).
Note: When preset settings are copied from the full Moog Filter version to
the SE version, the Boost (+20) switch value is retained, even though the
parameter is not available for SE. If you subsequently copy from SE back to
the full version, the original Boost value is pasted.
Figure 128. The UAD Moog Filter SE plug-in window