User Manual

UAD Powered Plug-Ins Manual - 351 - Chapter 38: Moog Multimode Filter
Offset can create great stereo spacial effects. When the filter is in Mono
mode, both filters are still heard.
Tip: Click the knob label (“OFFSET”) to return the value to zero.
Mix Mix varies the amount of filtering that is occurring. It is not a true dry/wet con-
trol; it mimics the mix function on the MF-101 Moogerfooger. When Mix is at
zero, the Drive/Gain control (and Boost on non-SE version) are still active and
audible.
Setting Mix at zero is the same as setting the Effect/Bypass switch to Bypass.
Stereo/Mono The left and right channel filters are always independent in the UAD Moog Fil-
ter. However, when this switch is set to Mono, the left and right output chan-
nels are summed. In Stereo mode, the left/right separation is retained.
Output The Output control changes the gain at the output of the plug-in. The available
range is ±20dB.
Output LED This LED gives a visual indication of the plug-in output level. The Out-
put LED is active when Bypass is enabled, but not when Power is off.
When the LED is red, the output is 0dBfs.
Effect/Bypass When Bypass is enabled, filter processing is inactive. Drive/Gain and Output
still operate in Bypass mode. Enabling Bypass has the same effect as setting
Mix to zero.
If the Free/Sync switch is set to Free, the LFO phase is reset to zero when
Bypass is switched to Effect.
Boost Boost shifts the “Drive” gain range up a full 20dB, while simultaneously shift-
ing the Output range down -20 dB. This mimics the behavior of the external
input on the Minimoog.
Note: This control is not available on the SE version.
Power Power disables the plug-in altogether and disables DSP processing. When
off, the background will “dim” much in the same way the Voyager's panel
does when powered off.