User Manual

UAD Powered Plug-Ins Manual - 287 - Chapter 32: Plate 140
Mix Knob The Mix control determines the balance between the original and the
processed signal. The range is from Dry (0%, unprocessed) to Wet
(100%, processed signal only).
This control uses a logarithmic scale to provide increased resolution
when selecting lower values. When the knob is in the 12 o’clock position, the
value is 15%.
Note: If Wet Solo is active, adjusting this knob will have no affect.
Wet Solo Button The Wet Solo button puts Plate 140 into “100% Wet” mode. When
Wet Solo is on, it is the equivalent of setting the Mix knob value to
100% wet.
Wet Solo defaults to On, which is optimal when using Plate 140 in the “clas-
sic” reverb configuration (placed on an effect group/bus that is configured
for use with channel sends). When Plate 140 is used on a channel insert, this
control should be deactivated.
Note: Wet Solo is a global (per Plate 140 plug-in instance) control. Its value
is not saved within presets.
Power Switch This toggle switch enables or disables Plate 140. You can use it
to compare the processed settings to that of the original signal,
or to bypass the plug-in which reduces (but not eliminates) the
UAD DSP load.
Power Lamp The red power indicator glows brighter when the plug-in is enabled by the
Power switch.