User Manual

UAD Powered Plug-Ins Manual - 286 - Chapter 32: Plate 140
Low Frequency
Knob
This parameter specifies the low shelving band transition frequency to be
boosted or attenuated by the low band Gain setting. The range is 20Hz to
2kHz.
Because this is a shelving EQ, all frequencies below this setting will be af-
fected by the low band Gain value.
Low Gain Knob This parameter determines the amount by which the transition frequency set-
ting for the low band is boosted or attenuated. The available range is ±12dB,
in increments of 0.5dB (fine control) or 1.0dB (coarse control).
High Frequency
Knob
This parameter determines the high shelving band transition frequency to be
boosted or attenuated by the high band Gain setting. The range is 200Hz to
20kHz.
Because this is a shelving EQ, all frequencies above this setting will be af-
fected by the high band Gain value.
High Gain Knob This parameter determines the amount by which the frequency setting for the
high band is boosted or attenuated. The available range is ±12dB, in incre-
ments of 0.5dB (fine control) or 1.0dB (coarse control).
Output VU
Meter
The vintage-style VU Meter represents the plug-in output
level. It is active when the Power switch is on, and slowly
returns to zero when Power is switched off.
Predelay Knob The amount of time between the dry signal and the onset of the reverb
is controlled with this knob. The range is 0.0 to 250 milliseconds.
This control uses a logarithmic scale to provide increased resolution
when selecting lower values. When the knob is in the 12 o’clock po-
sition, the value is 50 milliseconds.
Width Knob This control narrows the stereo image of Plate 140. The range is from
0 – 100%. At a value of zero, Plate 140 returns a monophonic re-
verb. At 100%, the stereo reverb field is as wide as possible.