Operator Instructions Includes - Foreseen Use, Work Stations, Putting Into Service, Operating, Dismantling, Assembly and Safety Rules Manufacturer/Supplier Important Read these instructions carefully before installing, operating, servicing or repairing this tool. Keep these instructions in a safe accessible place. Product Type Universal Air Tool Company Limited Unit 8 Lane End Industrial Park High Wycombe Bucks HP14 3BY Tel No (01494) 883300 Fax No (01494) 883237 0.
pneumatic motor lubricating oil preferably incorporating a rust inhibitor. Reconnect tool to air supply and run tool slowly for a few seconds to allow air to circulate the oil. If tool is used frequently lubricate on daily basis and if tool starts to slow or lose power. It is recommended that the air pressure at the tool whilst the tool is running is 90 p.s.i./6.3 bar. The tool can run at lower and higher pressures with the maximum permitted working air pressure of 100 p.s.i./7.0 bar.
UT049 & UT7X (HP049 & 7X) Ref No 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 0.498” Diameter Shank Air Hammers Part No 853001 853002 853002A 853003 853004 853005 853006 853007 853008 853009 853010 853011 853012 853013 853014 853015 853016 853017 853018 853019 853020 853021 853022 Description Handle Cylinder (3.8" Stroke) Cylinder (5.
Declaration of Conformity Universal Air Tool Company Limited Unit 8, Lane End Industrial Park, High Wycombe, Bucks, HP14 3BY, England declare under our sole responsibility that the product Model UT049 & UT7X Air Hammers, Serial Number EN792 (Draft), EN292 Parts 1 & 2, ISO 8662 Parts 1 & 2, Pneurop PN8NTC1 following the provisions of 89/392/EEC as amended by 91/368/EEC & 93/44/EEC Directives to which this declaration relates is in conformity with the following standard(s) or other normative document(s) Lan
