Operation Manual

PAG.

rev 1.1

English

TOOLS

6.5. SOFTWARE UPGRADE

There are two ways of upgrading the software of the receiver as

you can see at OSD 81.

6.5.1. RS232 UPGRADE

1. This function allows you to upgrade the software of the

receiver. This can be done from PC to receiver or from a master

receiver to a slave receiver.

2. Connect master receiver or PC to the slave receiver via serial

interface (0-Modem cable). Enter the “Software Upgrade”

menu of the master receiver and press [ ] to change the

upgrade mode. Upgrade modes include: allcode / maincode /

radioback / defaultdb / userdb (OSD 82).

3. Switch on the slave receiver.

4. Mark “Start” on the master reeciver and press [OK] to

start upgrade. Wait until the display on the front panel shows

“END”. Then switch off the receiver and on again. Now the new

software is used.

7. Press [Exit] to save the setting without upgrade.

For more information about software upgrade, please visit

http://www.universbyfte.com.

6.5.2. UPGRADE BY SATELLITE

This function can upgrade the software of your receiver through

data sent by a satellite. At the moment we offer satellite updates

only through ASTRA1 satellite.

1. Select the satellite and TP or input the TP value and

download PID.

2. Then mark “Start” and press [Enter] to begin the download

of the upgrade (OSD 83). This may need up to 60 Minutes.

Therefore we suggest using of this function only if you don’t

intent to watch TV during this time.

At the moment of writing this manual, the data for the software

upgrade by Satellite is:

•Satellite: Astra

•TP Frequency: 12604 MHz.

•Symbol Rate: 22000

•Polarity: Horizontal

•Download PID: 1277

For changes in the data of the satellite please visit http://www.

universbyfte.com .

OSD 81

OSD 83

OSD 82