Instruction Manual

Thread the Cross Bolts in the circular holes in Rail
Clamp A via the pass-through and into the Hex Nuts in
Rail Clamp B. Finger tight both before applying torque
to either. Torque to 5 in-lbs (0.57 Nm).
Fully seat the Hex Nuts in the recesses in Rail Clamp B.
Route cables from AXON™ to devices and fully seat
plugs in sockets. Avoid sharp bends and routing over
extreme heat areas and sharp edges. If using zip tie
loops for cable management, carefully pass slack
cable through loops and tighten ties.
[e-mail]
©2022 UNITY Tactical. All Rights Reserved.
Specifications subject to change without notice. PATENT PENDING
M A D E I N T H E
U S A
4
3
5