Instruction Manual

Table Of Contents

If using Front BUIS, thread into place through

bottom of FAST Mount so tip of post is

generally aligned with Rear BUIS. DO NOT

USE THREAD LOCKER.

Remove current mount from optic and set

it aside.

Using supplied mounting screws, install

the optic to mount. Tighten the screws in

an “X” pattern until they are finger tight.

Then give each screw a 1/8 - 1/4 turn

with the supplied wrench. DO NOT

EXCEED MANUFACTURER’S RECOMMENDED

TORQUE SPEC.

MICRO MOUNT

WARNING: Over-torquing fasteners can damage your mount and will not be covered by warranty.

PAGE 1
MICRO MOUNT WARNING: Over-torquing fasteners can damage your mount and will not be covered by warranty. 1 If using Front BUIS, thread into place through bottom of FAST Mount so tip of post is generally aligned with Rear BUIS. DO NOT USE THREAD LOCKER. 2 Remove current mount from optic and set it aside. 3 Using supplied mounting screws, install the optic to mount. Tighten the screws in an “X” pattern until they are finger tight. Then give each screw a 1/8 - 1/4 turn with the supplied wrench.
PAGE 2
MICRO MOUNT 4 If using Standard Rail Grabber Mount clamp, install the mount on weapon. Secure screws using a T25 bit driver. Lightly snug all screws before applying final torque to any. TORQUE TO 35 IN-LBS. 5 Optional ADM Quick Detach Lever (sold separately) can be installed in place of rail grabber. Installation instructions are included with lever. Compatible ADM QD Lever Kit with proprietary nut (see reference image) available exclusively from Unity Tactical and their dealers.
PAGE 3
MICRO MOUNT 5 Windage adjustment of Rear BUIS is 0.5 MOA/click (with a 12.5” Sight Radius). If in conjunction with included Front BUIS, adjustment is 5 MOA/click. Windage adjustment can be made with Aimpoint adjustment tools or flat blade screwdriver. 6 Elevation adjustment for Front BUIS is 10 MOA per 1/8” turn (keep in mind this is a 1.27” Sight Radius. So, yeah: Elevation is going to be pretty touchy.