User's Manual

26
CUSTOMIZATION
Pairing remote with detectors
1. Ensure all of your detectors are set
to the same radio key. Remove the
back cover from each detector and
locate the radio key by referring to
the component diagrams in this
guide.
2. Choose any combination of up
and down for the keys and repeat
it identically for all detectors.
3. Put your remote in pairing mode by
holding down the acknowledge
button for approximately 6
seconds. The green and yellow LED
icons will alternately illuminate.
When they do, release the
acknowledge button.
4. Once the 2 LED icons on the
remote begin alternating, press the
test button on any one of your
detectors. If the pairing is
successful, all 4 LED icons will
alternately illuminate.
5.
Pairing is complete for all detectors.
6. Press the test button of any of the
detectors to check if the pairing
was successful. Your Smart Alert
remote should now give you the
alerting signal.
7. If pairing is not successful,
repeat Steps 3-6.
Customizing your Doorbell detector
Changing the The BE 1023 doorbell
detector recognizes the sound emitted
by a doorbell. If the doorbell is
electromechanical it can also detect
the electromagnetic field emitted
by the doorbell.
Inside the battery compartment a
function switch can be modified to
further customize the doorbell detector.