Instruction manual

Revision date: 26.02.2013 Page 9 of 32
POLARITY SELECTION
In the picture below the cable supplying current to the Euro-connector is connected to the machine plus-
connection. The cable to return current (ground clamp) then has to be connected to the machine minus-
connection to the right in the picture. This means the machine is set for welding with electrode plus polarity
from the Euro-connector to the right, which is the normal setting for MIG/MAG welding.
For Self-shielded wires (without shielding gas) and for TIG welding the minus polarity should normally be
selected, and the return clamp should be connected to the plus polarity.
For stick electrode welding (MMA) the cable in the picture is disconnected as shown in the drawing, and
electrode cable and return cable are connected to plus and minus according to the requirements of the
electrode that is going to be used.
+
_
Euro-connector for
TIG and MIG torch
The outgoing wire
guide tube is inserted
here, slightly bent to
prevent it from falling
out when the MIG
torch Euro-connector is
disconnected.
,