Technical data

After Work
• Switch off machine by means of the ON/OFF switch (2).
• Depressurize spray pistol by shortly opening
and closing.
• Lock spray pistol.
• Disconnect machine from water and power source.
• Thoroughly clean high pressure hose. In case of damage
(cuts, abrasions, kinks, etc.) replace high
pressure hose for safety reasons.
• Only original Unitor high pressure hoses (marked) to be
used. Otherwise EC Declaration of Conformity and warranty will
expire.
• Reel up high pressure hose properly without any loops.
• Store machine and accessories in a dry, frost-protected area.
• Drain pump completely in case of extended shut-down periods.
Particularly note:
In case of malfuctions, eliminate cause according to chapter „Trouble
Shooting“, call qualified service.
In case frost is likely, frost protection to be carried out (see chapter
„Maintenance and Care“), otherwise severe damage will be the result.