Instructions / Assembly
Ceramic Fiber Blanket
Safety Data Sheet
MSDS Number: INS-051418
Revision Date: 3-23-16
Page 2 of 5
5. FIRE FIGHTING MEASURES
Non-combustible (does not burn) product.
Auto-ignition temperature: none
NFPA Unusual Hazards: none
Unusual re and explosion hazards: none
Extinguishing Media: use proper extinguishing media for the surrounding re.
Fire ghting protective equipment: wear full bunker gear including positive pressure self-
contained breathing apparatus.
6. ACCIDENTAL RELEASE MEASURES
Avoid creating airborne dust. Maintain routine housecleaning procedures. Vacuum only
with HEPA ltered equipment, if sweeping is necessary, use a dust suppressant and keep
material in closed containers. Do not use compressed air for cleanup. Workers should
wear gloves, goggles and approved respirator. Avoid cleanup procedures that could
cause water pollution.
7. HANDLING AND STORAGE
CLEAN-UP:
Clean up dust carefully. Use wet sweeping or high efciency vacuum to remove dust.
Do not use compressed air.During after-service removal activities, wet exposed material
frequently to minimize airborne dust. A surfactant may be added to the water to improve
the wetting process. Use only enough water to wet the insulation. Do not allow water to
accumulate on oors.
EMPTY CONTAINERS:
Product packaging may contain residue. Do not reuse.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Components OSHA Supplier:
Alumino--silicate ber None established
ACGIH TLV:
Aluminosilicate ber—none established
For Alumino--silicate ber, refer to OSHA guidance regarding”Particulates not otherwise
Regulated”(PNOR). Control airborne dust levels as follows:
Components Particle size OSHA:
PNOR total dust 15mg/m3