Specifications

VersaPro Temperature Controller Page 66
Copyright © 2013, United Process Controls Inc. All rights to copy, reproduce and transmit are reserved
Parity: Even, odd, or None
Control Mode
Time Proportioning Single Contact Direct
Time Proportioning Single Contact Reverse
Time Proportioning Dual Contact Direct
Time Proportioning Dual Contact Reverse
Time Proportioning Complement Contact Direct
Time Proportioning Complement Contact Reverse
Position Proportioning Direct
Position Proportioning Reverse
On / Off Direct
On / Off Reverse
On / Off Dual Direct
On / Off Dual Reverse
On / Off Complement Direct
On / Off Complement Reverse
Alarm Type (both Alarm 1 and 2)
High Limit Temp
Low Limit Temp
Process Deviation Band
Process Deviation High
Process Deviation Low
Control Percent Out
Input Fault (mV or Thermocouple)
Time (start timer no conditions)
Start (guaranteed timer at setpoint)
Soak (guaranteed timer run in band)
Digital Event Input (isolated contact closure)
Probe Burnoff
Manual/Auto
Local/Remote
Alarm Acknowledgement
Freeze Process
Start Timer
Hold Timer
Acknowledged Timer End
20.4 Electrical safety (pending approval)
Standards: EN 61010, Installation category II, pollution degree 2.
Installation category II: Voltage transients on any mains power connected to the instrument must not
exceed 2.0 kV.
Pollution degree 2: Conductive pollution must be excluded from the cabinet in which the instrument
is mounted.
Environmental Conditions
Operating Temperature -20 °C to 65 °C (-4 to 176 F)