Specifications

VersaPro Temperature Controller Page 30
Copyright © 2013, United Process Controls Inc. All rights to copy, reproduce and transmit are reserved
Parameter Name Units or Options Range Description
BAUD RATE 1200,2400,4800,9600,19.2K Default is 19.2K
PARITY None/Even/Odd Modbus is always None
DELAY NONE / 10 / 20 / 30 NONE = 0 Delay
10 = 10 ms delay
20 = 20 ms delay
30 = 30 ms delay
Table 9 Info Menu (InFO)
Parameter Name Units or Options Range Description
MILLIVOLT TEMP IN MILLIVOLTS -10-100 Displays direct mV of
Temperature input also called
Input A in linear mode.
MILLIVOLT PROB IN MILLIVOLTS 0-2000 Displays direct mV reading of
probe input as called Input B in
linear mode.
COLD JUNCTION DEG (F OR C) 0 – 60°C Displays actual cold junction
temperature
PERCENT OUTPUT % Output LOPO to HIPO Displays actual % output
FIRMWARE REV Version number
Table 10 Calibration Menu
Parameter Name Units or Options Range Description
CAL INPUT NO / YES Default to NO, must be changed
to YES to enter input calibration
routine.
TC ZERO
(CAL IN)
Changes calibration value for
thermocouple zero
TC SPAN
(CAL IN)
Changes calibration value for
thermocouple span
PROBE mV ZERO
(CAL IN)
Changes calibration value for
millivolt zero
PROBE mV SPAN
(CAL IN)
Changes calibration value for
millivolt span
CJ OFFSET
(CAL IN)
0 – 60° C
0 – 140° F
Sets the cold junction offset
depending on the temperature
range selected
CAL OUTPUT NO / YES Default to NO, must be changed
to YES to enter output calibration
routine.
OUTPUT 1 MIN
(CAL OUTPUT)
Sets signal level for the minimum
mA output.
OUTPUT 1 SPAN
(CAL OUTPUT)
Sets signal level for the maximum
mA output.
OUTPUT 2 MIN
(CAL OUTPUT)
Sets signal level for the minimum
mA output.
OUTPUT 2 SPAN
(CAL OUTPUT
Sets signal level for the
maximum mA output.