Specifications

4
GENERAL INFORMATION
Read and save this installation and operating manual before proceeding with installing or operating the
MP CONTROLLER.
1. The MP CONTROLLER has been carefully inspected and tested before leaving the factory.
2. Examine the controller components (SENSOR and DISPLAY units) for any damage that might have
occurred during transit. Please notify the carrier if there is any damage.
3. Installation of the MP CONTROLLER should be performed by qualified personnel.
THE MP CONTROLLER COMPONENTS
The MP CONTROLLER is made up of three components.
MAIN BOARD
The MAIN BOARD (Fig 1) is an electronic component located inside an electrical box of the unit.
It controls all the functions of the compressors, fans, humidifier, etc. Only qualified personnel
should access the board.
Temperature / Humidity SENSOR
The Temperature/ Humidity sensor (Fig 2) is wall mounted. The sensor measures the temperature and
humidity of the conditioned space and provides the controller with the data for the control actions.
Fig 1 Main Board Fig 2 Temperature / Humidity SENSOR