User's Manual

48
Copyright 2012 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
The Display Criterion # spin box allows you to select the criteria currently being viewed. It has
a range of one (1) up to the value displayed under Active Criteria.
The Load button causes the application to perform a direct query to the current reader and
reload the page with the retrieved post singulation criteria settings.
To change the post singulation criteria parameters for the active reader, click the Edit button.
This displays the dialog box shown in the figure below.
Post Singulation Criteria Edit Dialog
This page allows configuration of individual post singulation criterion parameters.
Note: Only one active post singulation criteria is allowed at this time. Attempts to set the Active Criteria count
greater than one (1) in the Edit dialog result in an Invalid Parameter error. This error is generated and displayed
when the Save button is clicked.
GPIO Pin Configuration Page
Use the GPIO Pin Configuration page to set and retrieve the current values of General
Purpose Input/Output (GPIO) pins which are accessible to the user on the Indy Firmware
microcontroller. The figure below shows the GPIO panel.
GPIO Pin Page