User`s manual

Chapter 3 Getting Connected
34
Copyright 2009 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
2. Under the Main tab, select the desired profile
to activate.
3. A window appears with the message: A
Power Cycle is required to make settings
activate properly. Tap OK → OK to exit the
Summit Client Utility.
4. Tap Start → Programs → Utilities → Boot-
Mode. Tap Warm Boot to Warm Start the
PA968 and load previous settings.
5. The Summit icon appears on the taskbar indi-
cating the AP connection.
Double-tap this icon to access the Summit
Control Utility. Tap Disable Radio to discon-
nect the AP.
Under the Status tab view the IP address, sig-
nal strength and signal quality.