User`s manual

30
Copyright 2009 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Wi-Fi Connection
Unitech terminals come with a built-in RF facility. Add a wireless network when the
network is detected or by manually entering setting information. Before following
these instructions, check to make sure if any authentication information is needed.
1. Tap Start → Programs → Summit → scu.
The Summit Client Utility window appears.
2. Select ThirdPartyConfig from the Active
Profile: drop down menu.
3. A window appears with the message: A
Power Cycle is required to make settings
activate properly. Tap OK → OK to exit the
Summit Client Utility window.