User`s manual

Chapter 2 Using the Hardware
19
2. The Scanner Control Panel opens.
From here you can configure barcode scanner parameters such as enabling or
disabling barcode symbologies, setting data transmission options, configuring
magnetic and proximity reading options, and setting power management
options.
3. To test the barcode scanner, tap the Test
tab
4. Tap Tools.
5. Tap Enable Scan
6. To perform auto scan,tap Tools --> Auto
Scan --> Start auto-scan.
7. Choose Interval: 3 secs
8. Tap Start
9. Laser scan every 3 seconds and barcode is
scanned automatically.
10. Tap Tools --> Auto-Scan --> Stop
AutoScan.
11. To enable the scanner outside of the test
tab, user must enable Scan2Key.exe.This
can be done via the To Kpd tab.