User`s manual

By scanning the labels from top to bottom sequentially, you may duplicate the rest

of scanners with the same settings.

The following issues should be observed:

 The sequence of the strings that the scanner dumped is important. You have to

print the bar code labels and scan them in the same sequence as the one that

the scanner dumped.

 When you scan the batch setup labels to configure a scanner, the previous

settings on that scanner are reset to default and then replaced by the settings

contained in the batch labels.

 Only the settings that are different from the default values will be dumped. So

the number of labels produced depends on how many settings being changed

compare to the factory default setting.

 The settings can be dumped to a PC or terminal only if that PC or terminal

matches the type defined by Device Type of the scanner. The previous

example of “Keyboardless Wedge” as Device Type is equivalent to a PC/AT

interface, so you cannot dump that settings to a system which dose not

support a PC/AT keyboard interface.

The following label let you dump the settings to a PC/AT regardless what kind of

device has been chosen on the scanner.

Dum

Settin

s On PC/AT

 You can adjust the length of the dumped strings by combining multiple strings

into one or breaking one string into multiple strings. The following strings have

the same effect as the dumped string listed above:

...I800C06D51DJ8080

80A0O7C005354415254.

You cannot delete any character from or add any character into the strings and the

first three characters (“...”) must present in the first string.

 All characters in dumped strings are in upper case. If you see lowercase

characters in dumped strings, change them to upper case.