User`s manual

By scanning the labels from top to bottom sequentially, you may duplicate the rest
settings.
scan them in the same sequence as the one that
ped.
ous
that are different from the default values will be dumped. So
bels produced depends on how many settings being changed
al
evious
Wedge” as Device Type is equivalent to a PC/AT
not
of scanners with the same
The following issues should be observed:
 The sequence of the strings that the scanner dumped is important. You have to
print the bar code labels and
the scanner dum
 When you scan the batch setup labels to configure a scanner, the previ
settings on that scanner are reset to default and then replaced by the settings
contained in the batch labels.
 Only the settings
the number of la
compare to the factory default setting.
 The settings can be dumped to a PC or terminal only if that PC or termin
matches the type defined by Device Type of the scanner. The pr
example of “Keyboardless
interface, so you cannot dump that settings to a system which dose
support a PC/AT keyboard interface.
The following label let you dump the settings to a PC/AT regardless what kind of
device has been chosen on the scanner.
Dum
p
Settin
g
s On PC/AT
 You can adjust the length of the dumped strings by combining multiple strings
ing into multiple strings. The following strings have
listed above:
C005354415254.
from or add any character into the strings and the
t present in the first string.
wercase
characters in dumped strings, change them to upper case.
into one or breaking one str
the same effect as the dumped string
...I800C06D51DJ8080
80A0O7
You cannot delete any charac
first three characters (“...”) mus
ter
 All charac ngs are in upper case. If you see loters in dumped stri
23