User manual

Copyright © 2011, Unitech America Inc. All rights reserved.
Page 54 of 61
MS246 User Manual
SyncCheck
ID
7B
Check for
track sync bits
‘0’ (‘0’-2’)
Check leading & trailing
sync bits on track data (if
poorly encoded card)
ErrorZoneID
*
7C
None
Security
LevelID
7E
‘0’ key exhausted; ‘1’
non-encrypted; ‘1’ key
loaded non encrypted
‘3’ encrypted; ‘4’
n
r
Encrypt
OptID
84
Encryption
options
8 encrypt trk
3 if card type
0; (0-F)
Bit 0 encrypt trk1; bit 1
encrypt trk2; bit 3 encrypt
trk3; bit 4 encrypt trk3 if
card type 0
EncryptStrID
85
Encrypt
structure
'0'
‘0’ original; ‘1’ enhanced
MaskOptID
86
Clear / mask
data options
7
Bit 0 send clear/mask trk1
Bit 1 send clear/mask trk2
Bit 2 send clear/mask trk3
WinCETestI
D*
AA
None
PrefixID
D2
Preamble
0
No Preamble, 15 char max
PostfixID
D3
Postamble
0
No Postamble, 15 char
max
AddedFieldI
D*
FA
DE Added
Field
0
No added field
-
SearchCmdI
D*
FB
DE Search
Cmd
0
No search command
-
SendCmdID*
FC
DE Send Cmd
0
No send command
-
*Unused entries in this table were left for completeness even though unused in the
MS246 reader to avoid conflicting definitions between products.
Note not all function ID are present in different hardware versions of the MS246. The last
column above has some codes:
‘-‘ feature not currently supported; exists for compatibility.
‘s’ feature not available in the USB version.
‘u’ feature available only in the USB version.
‘k’ feature not available in the USB version.
‘r’ reset all does not affect this value.
‘n’ not directly settable.
Most function ID settings that relate to the content of formatting of the track output do
not work in secure mode. Exceptions to this are Preamble and Postamble in keyboard
mode only.
It is currently not possible to mix security with OPOS and JPOS support.