User manual

Page 18 of 61

MS246 User Manual

Where:

<FuncID> is one byte identifying the setting(s) for the function.

<Len> is a one byte length count for the following function-setting block <FuncData>.

<FuncData> is the current setting for this function. It has the same format as in the

sending command for this function.

<FuncSETBLOCK> are in the order of their Function ID<FuncID>.

7.9 Set MSR Options Command

The default value is listed in bold.

7.9.1. Beep Volume

The beep volume and frequency can each be adjusted to two different levels, or

turned off.

02 53 11 01 <Beep Settings>03 LRC

Beep Settings:

‘0’ for beep volume off.

‘1’ for beep volume high, low frequency.

‘2’ for beep volume high, high frequency.

‘3’ for beep volume low, high frequency.

‘4’ for beep volume low, low frequency.

7.9.2. Change to Default Settings

02 53 18 03 LRC

This command does not have any <FuncData>. It returns all non-security settings

for all groups to their default values.

7.9.3. MSR Reading Settings

02 53 1A 01<MSR Reading Settings> 03 LRC

MSR Reading Settings:

‘0’ = MSR reading disabled.

‘1’ = MSR reading enabled.

7.9.4. Decoding Method Settings

02 53 1D 01<Decoding Method Settings> 03 LRC.

Decoding Method Settings:

‘0’ = raw data decoding in both directions.

‘1’ = decoding in both directions.

‘2’ = moving stripe along head in the direction of encoding.