User`s manual

13
Chapter 5
Setup
The scanner interface can be configured to fit the user's specific application.
Configuration parameters are stored in a non-volatile memory, which is retained
even if power is lost.
Barcode Menu Setup
The setup menu in Appendix C contains eight groups:
Group 1: Device selection.
Group 2: Beep and delay.
Group 3: Keyboard and Wand Emulation.
Group 4: RS-232 Settings.
Group 5: Scanner port.
Group 6: Code 39,1 2 of 5, S 2 of 5 and Code 32.
Group 7: Code 128, Code 93, Code 11, Codabar, and MS.
Group 8: UPC/EAN
Group 9: Dump setup
Setup Procedures
For most parameters, proceed the following steps for the setting:
1) Locate a group that contains the parameter to be changed.
2) When you hear beep, the new setting will have been defined or updated
into the memory processor.
Default parameters are indicated in bold type and underlined characters. The
character font is BLACK.CD = Check Digit.
CDV = Check Digit Verification.