User's Manual
Table Of Contents
- About This Manual
- Getting Started
- Using the Hardware
- Making RFID Applications
- Using Smart-Reader Server
- Controlling Smart-Reader Server Remotely
- Installing Microsoft .NET Framework
- Installing the SRSRC Program
- Using the Smart-Reader Server Remote Control
- Configuring Antenna Port
- Defining Smart Reader Behavior
- Creating a New EC Spec
- Specifying Report Criteria
- Setting up Filter Rules
- Defining the EC Spec
- Subscribing the EC Spec
- Redefining the Subscription
- Viewing Data Collection Report
- Viewing Server Log
- Using the Application Programming Interface
- Connecting to BizTalk Server
- Connecting to Oracle Sensor Edge Server
- Advanced Settings
- Troubleshooting
- System Specification
- Support
Chapter 3 Making RFID Applications
15
3. In the Inventory Times: field, input the Inventory Times for reading times within
the reading period (0ms by default). A setting of 0 or 8192ms is recommended,
but it depends on the local environment.
NOTE: The Antenna Switch Time and the Inventory Times cannot both be
simultaneously set at 0.
4. Click Apply to save the settings.
Antenna ports switch when the Antenna Switch Time or Inventory Times run out. If
installed properly, the Tags screen will display any data collected from the antennas.
Click Clear at the bottom of the screen to view the fresh data. See Installing RFID
Antenna (Optional) on page 7.
NOTE: The red DATA LED flashes on the RS700’s front panel, indicating data
collection.
Defining Smart Reader Behavior
In the left pane, click Event Management. In the right panel, define the event cycle
specifications, specify the report criteria and the setup filter rules.