User's Manual
Table Of Contents
- About This Manual
- Getting Started
- Using the Hardware
- Making RFID Applications
- Using Smart-Reader Server
- Controlling Smart-Reader Server Remotely
- Installing Microsoft .NET Framework
- Installing the SRSRC Program
- Using the Smart-Reader Server Remote Control
- Configuring Antenna Port
- Defining Smart Reader Behavior
- Creating a New EC Spec
- Specifying Report Criteria
- Setting up Filter Rules
- Defining the EC Spec
- Subscribing the EC Spec
- Redefining the Subscription
- Viewing Data Collection Report
- Viewing Server Log
- Using the Application Programming Interface
- Connecting to BizTalk Server
- Connecting to Oracle Sensor Edge Server
- Advanced Settings
- Troubleshooting
- System Specification
- Support
Chapter 2 Using the Hardware
9
Mounting the RS700
The RS700 comes standard with a wall mounting kit for easy installation.
Mount the RS700 to a wall through the following:
• Plastic conical anchor (4) 3x25mm.
• Self-tapping screw (4) 3.5x19mm.
1. Locate the four mounting holes on the RS700.
2. Place the RS700 on the wall. Mark the mounting hole locations with a pen.
3. Remove the RS700 and drill four 1/4-inch wide holes at least one inch deep.
4. Insert the four plastic conical anchors into the holes.
5. Secure the RS700 to the wall with the four self-tapping screws, and insert them
into the plastic conical anchors.
Mounting
Holes
Mounting
Holes